Manx SA7x Installationsanleitung PDF herunterladen (Seite 20)

If the H405–E/F revision level is:

a. Revision H07 or above for H405–E, Revision J07 or above for H405–F:

• The H405–E/F power controller contains unswitched ac outlets.

• Replacement of the H405–E/F is unnecessary.

b. Below revision H07 for H405–E; below revision J07 for H405–F:

• The H405–E/F power controller contains switched ac outlets.

• Continue this procedure to replace the H405–E/F.

7. Replace the H405–E/F power controller with the one in the 62X34–UA/UB upgrade kit.

3.3.1.1 H405–E/F VAX 6000 Power Controller Removal and Replacement

To remove and replace the H405–E/F VAX 6000 power controller, refer to the VAX 6000

Platform Service Manual (EK-600EA-MG).

3.4 Relocating the Rear ESD Packet

The rear ESD packet in the drive cavity of the VAX 6000-series processor cabinet must be

removed to install enclosures. To remove and relocate the ESD packet, use the following

procedure:

1. Open the rear door, using a 5/32 hex key.

2. Locate the rear ESD packet taped to the inside of the cabinet drive cavity. Some cabinets

do not have this packet.

3. Remove the small Phillips screw that attaches the rear ESD ground strap to the cabinet

and remove the tinneman nut.

4. Grasp and pull the rear ESD packet, removing it from the drive cavity.

5. Stick the rear ESD packet to the rear door as shown in Figure 3–2.

6. Secure the rear ESD ground strap to the rear door ground lug as shown in Figure 3–2.

Note

Some cabinets have the rear ESD packet already installed on the rear door.

3.5 Preparing the Cabinet for SA7x Installation

To ensure customer safety, install SA7x upgrade kits. The original VAX 6000-series cabinet

doors must be removed and a new door with SA7x operator control panel access installed. The

new door (70–26931–01) allows customers to access the SA7x operator control panel without

opening cabinet front door. Refer to Figure 3–1.

To remove the original door:

1. Open the cabinet front door with a 5/32 hex key.

2. Remove the screw securing the front door ground strap to the cabinet frame.

3. Pull up on the top front door key pin, locking the key pin in the upper position.

3–6 Installing the SA70–CK Kit

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Keine Kommentare

Manx SA7x Installationsanleitung Seite 20