Manx SA7x Installationsanleitung PDF herunterladen (Seite 33)

Figure 3–11: Repositioning Transition Board 1

CXO-2797A

TRANSITION

BOARD 1

(BEHIND FRAME)

SLOTTED

HOLE

SLOTTED

HOLE

HOLE FOR

TB1 RIGHT

POSITION

HOLE FOR

TB1 LEFT

POSITION

TRANSITION

BOARD 2

SCREWS

2. Remove the center screw from transition board 1.

3. Loosen the corner screws in the slotted holes of the board.

4. Slide transition board 1 to the left.

5. Install and tighten the center screw in the hole for TB1 left position as shown in

Figure 3–11.

6. Tighten the corner screws in the slots.

7. Replace the SA7x enclosure operator control panel by lining up the connectors and pushing

the operator control panel into the enclosure.

3.7.5 Routing the SA7x Enclosure Cables

Steps 1 through 9 of the following procedure details cable routing for the ﬁrst SA7x enclosure

installed in the left side of the cabinet. Step 10 of this procedure details the cabling of the

second SA7x enclosure, installed in the right side of the cabinet. Route the SA7x enclosure

cables as follows:

1. Plug the female end of the SA7x enclosure power cord (17–00442–27) into the SA7x

enclosure.

Installing the SA70–CK Kit 3–19

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Keine Kommentare

Manx SA7x Installationsanleitung Seite 33