Manx SA7x Installationsanleitung PDF herunterladen (Seite 22)

3.6.2 Moving the ESD Strap

Use the following procedure to move and reattach the ESD strap:

1. Locate the front ESD packet, shown in Figure 3–4. The packet is adhered to a sheet

metal transformer shield plate located left of the drive cavity. The packet contains the

ESD ground strap, which is attached to the transformer shield plate in the top-right

corner.

2. Move the front ESD ground strap from the top hole to the middle hole on the transformer

shield plate. Attach the strap, using the middle hole screw, as shown in Figure 3–4.

Discard the top and bottom screws. These holes are used for installation of the SA7x

enclosure into the left drive position.

Figure 3–4: Relocating the Front ESD Strap

TOP ESD STRAP

MOUNTING HOLE

MIDDLE ESD STRAP

MOUNTING HOLE

ESD

PACKET

CABINET

FRONT

CXO-2791A

3–8 Installing the SA70–CK Kit

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Keine Kommentare

Manx SA7x Installationsanleitung Seite 22