Manx SA7x Installationsanleitung PDF herunterladen (Seite 102)

4.3 Dual-Host Installation of an SF3xx Storage Array

3. Install one end of the 108-inch DSSI cable (part number BC21Q–09) to the

I/O panel on the system cabinet (see Figure 4–11).

• Connect the DSSI cable from the DSSI port 1 (of the I/O panel) to the

ﬁrst DSSI connector of the ﬁrst KFMSA bulkhead connector on the

system I/O panel.

• Connect the DSSI cable from the DSSI port 2 (of the I/O panel) to the

second DSSI connector of the ﬁrst KFMSA bulkhead connector on the

system I/O panel.

• Connect the DSSI cable from the DSSI port 3 (of the I/O panel) to the

ﬁrst DSSI connector of the second KFMSA bulkhead connector on the

system I/O panel.

• Connect the DSSI cable from the DSSI port 4 (of the I/O panel) to the

second DSSI connector of the second KFMSA bulkhead connector on

the system I/O panel.

• Connect the DSSI cable from the DSSI port 5 (of the I/O panel) to the

ﬁrst DSSI connector of the third KFMSA bulkhead connector on the

system I/O panel.

• Connect the DSSI cable from the DSSI port 6 (of the I/O panel) to the

second DSSI connector of the third KFMSA bulkhead connector on the

system I/O panel.

4.3.3 Labeling the Cables (Dual-Host)

This section describes the steps to label correctly the cables for the host

systems, the SF3xx storage array, and its SF7x storage enclosures and

magazine tape subsystems.

At this point, all steps in the previous sections must be complete.

Digital Multivendor Customer Services or trained installing personnel must

perform the steps that follow.

4–18 Installing an SF3xx Storage Array to a VAX 6000 System

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 319 320

Keine Kommentare

Manx SA7x Installationsanleitung Seite 102