Manx SA7x Installationsanleitung PDF herunterladen (Seite 172)

6.2 Cabling the Subsystem in Sx300 Storage Array Position

7. Plug the other end of this cable into the appropriate port on the system I/O

panel at the rear of the system cabinet.

CAUTION

Do not apply power to the subsystem at this time.

8. Install a DSSI terminator in the bottom DSSI connector at the rear of the

subsystem.

6.2.2 Dual-Host Conﬁguration

Use the following procedures for cabling a magazine tape subsystem in an

existing Sx300 storage array conﬁgured for dual-host.

6.2.2.1 Cabling TF1

WARNING

Before performing the following steps, refer to the system documenta-

tion for the correct steps to perform an orderly shutdown of the system

that the Sx300 storage array is connected to.

1. Take the disk ISEs in position 1 off-line before you proceed. To do so, ﬁrst

take each ISE off-line by pressing the Ready buttons. Then press all the

drive dc power switches to the out position. Last, turn off the ac power at

the rear of the storage enclosure.

CAUTION

Use care not to disturb or damage power cords and DSSI cables that

are already connected to the DSSI I/O panel.

2. Disconnect the 70-inch DSSI cable (part number BC21R–5L) connected to

the rightmost DSSI connector at the rear of the SF72 enclosure in position

3. Connect the 70-inch DSSI cable removed from the SF72 storage enclosure

to the top DSSI connector on the rear of the magazine tape subsystem.

4. Route this DSSI cable on the right side of the cabinet.

6–20 Installing the Magazine Tape Subsystem in an Sx300 Storage Array

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 319 320

Keine Kommentare

Manx SA7x Installationsanleitung Seite 172