Manx SA7x Installationsanleitung PDF herunterladen (Seite 68)

3.16 Chassis Rail Installation (Universal Rails)

9. Fasten the chassis rail to the inner ﬂanges of the front and rear vertical

cabinet rails with 4 screws, as shown.

10. Fasten the rail bracket to the front vertical cabinet rail with its beveled

nut bar and three screws, as shown.

11. Fasten the chassis rail to the rear vertical cabinet rail with its beveled nut

bar and three screws, as shown.

12. Tighten the screws fastening the rail bracket to the chassis rail.

13. Install two U-nuts along the outer ﬂange of the front vertical cabinet rail.

Install one U-nut at the hole just above the front chassis rail locating hole

and the other at the eighth hole below the locating hole.

3.16.3 Left Position Chassis Rail Assembly Installation

Note

Install the chassis rail assembly in the left mounting position only if

an enclosure is also installed in the right position. The bezel openings

are designed to allow a single enclosure to be installed only in the right

position.

Install the chassis rail assembly in the left position within the cabinet as

follows (see Figure 3–9):

WARNING

Cabinet rail edges may be sharp and can slice or abrade skin or cable

insulation.

1. Turn the cabinet power off.

2. Determine the correct enclosure mounting locations and corresponding

cabinet rail mounting holes for the chassis rail assembly. Refer to the

chapter in this document pertaining to your speciﬁc cabinet conﬁguration

for this information. The enclosure mounting hole speciﬁed for each

position is the chassis rail locating hole shown in Figure 3–9.

3–26 Preparation and Installation

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 319 320

Keine Kommentare

Manx SA7x Installationsanleitung Seite 68