Manx SA7x Installationsanleitung PDF herunterladen (Seite 49)

3.3 Electrostatic Discharge

2. Wear a properly grounded ESD wrist strap when handling modules,

components, or static sensitive devices:

• Make sure the wrist strap ﬁts snugly for proper conductivity.

• Attach the alligator clip securely to a clean, unpainted, grounded,

metal surface such as the drive or cabinet chassis.

• Do not overextend the grounding cord.

3. Use static-protective containers to transfer modules and components

(including bags and tote boxes).

The ESD grounding strap for the DECArray300 cabinet system is attached to

the rear bustle inside the rear panel of the cabinet.

WARNING

Do not attempt the following procedures unless you have taken proper

precautions against ESD. Wear an ESD grounding strap with the clip

end securely connected to a known grounding point while removing the

storage element operator control panel (OCP) or other ESD-sensitive

components.

3.4 Removing and Replacing the Cabinet Front Bezels

Remove the cabinet front bezel as shown in Figure 3–2:

1. Grasp the lower edge of the bezel, and place your ﬁngers in the ﬁnger

cutouts (lower edge).

2. Lift up and pull forward. The top of the bezel should rock against the two

rubber bezel bumpers attached to the cabinet frame.

Note

Take care not to push the adjacent OCP out of place with the top edge

of the bezel during bezel removal. The operating disk or tape drive

may power down if this occurs.

Preparation and Installation 3–7

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 319 320

Keine Kommentare

Manx SA7x Installationsanleitung Seite 49