Manx SA7x Installationsanleitung PDF herunterladen (Seite 148)

5.2 Cabling the SF7x in Storage Array Position

Plug the other end of this cable into the leftmost DSSI connector at the

rear of the SF7x in SF6.

5. For the cable to port 6, route the DSSI cable on the right side. For the

cable to port 12, route the DSSI cable under the cable retainer on the left

side.

6. Plug two 108-inch DSSI cables (part number BC21Q–09) into ports 6 and

12. Tighten the retainer screws on the 108-inch DSSI cables with your

ﬁngers.

Note

The following step assumes that no SF7x storage enclosures are

installed internally in the system cabinet. If there are SF7x storage

enclosures installed in the system cabinet, then one of the KFMSA

modules installed in the system XMI backplane must be connected to

those SF7x storage enclosures. DO NOT USE this KFMSA module or

its DSSI connections to connect the system to the Sx300 storage array.

7. Plug the other end of the 108-inch DSSI cables into the appropriate ports

on the system I/O panel at the rear of the system cabinet. To determine

which of the two DSSI connectors on the system I/O panel to connect to:

a. Locate the DSSI connectors on the system I/O panel labeled

BLUE/WHITE and RED/WHITE.

b. From port 6 on the Sx300 I/O panel, connect the 108-inch DSSI cable to

the right DSSI connector (RED/WHITE) of the ﬁrst system I/O panel.

c. From port 12 on the Sx300 I/O panel, connect the 108-inch DSSI cable

to the right DSSI connector (RED/WHITE) of the second system I/O

panel.

CAUTION

Do not apply power to the SF7x enclosure at this time.

5–42 Installing the SF7x Storage Enclosure in an Sx300 Storage Array

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 319 320

Keine Kommentare

Manx SA7x Installationsanleitung Seite 148